So a few things went wrong before this. Here’s a log:
Starting the day and operating normally. Rode for a block before noticing back tire is flat.
Replaced tube. Filled to 45 psi
Mishandled the back wheel and over extended motor wire during repair (discovered this after 5)
Noticed back wheel not operating or spinning freely
Opened floorboard, removed battery and support foam, found rear motor pins disconnected and BURNED rubber connector rings ⚠️
Reconnected rear motor pins, reseated battery and foam (probably wrong) and operating normally. Ride is a little harder at 45 psi
Bumping noise coming from the floorboard
Rode for two miles before shutdown and LED error code.
Opened floorboard again and found disconnected battery cable from vibration.
Reconnected cables, operating but weaker acceleration.
☁️Maybe it factory reset after the battery disconnected? I’ll check and reconfigure when I get back.☁️
Nope.
Fully charge battery. Not that either.
What’s strange to me is the rear motor connectors are damaged and operating while the front isn’t (operating properly or visibly damaged).
Any guesses?
